eng
Nottingham
06:22
machine for repair of ball joints and steering tips SJR 3
machine for repair of ball joints and steering tips SJR 3 - photo 1 machine for repair of ball joints and steering tips SJR 3 - photo 2 machine for repair of ball joints and steering tips SJR 3 - photo 3 machine for repair of ball joints and steering tips SJR 3 - photo 4
Renewed: 18 November 2019, 09:25

Machine for repair of ball joints and steering tips SJR 3

$1,380/piece
Стил Александр
менеджер
,  Kharkiv, UA
Flagma member since 12 March 2018

Description

SJR 3 machine for repair of ball joints and steering tips is a guaranteed source of profit for your car service. With it, you can quickly and efficiently restore the suspension, steering device. The device has integrated furnace, and centering mechanism. This allows one operator to cope with repair steering tip.

When is a steering tip repair required?
Ball joints and steering tips wear out. As a result, the polymer insert located inside is erased. In its place a void forms. The reason for this are:

Excessive loads;
Penetration of dirt;
Movement on roads in poor condition.

The principle of using SJR technologySJR 3 machine
The molten polymer is fed into the interior into the cavity between the ball and the sleeve body through a drilled hole under pressure.
As it freezes, it forms a new, ideal in technical parameters, seal for the lever finger.
The restored unit is able to serve from 15,000 to 25,000 km, depending on the condition of the roads on which the car will ride;
In the event of the effects of new wear, repeated restoration of the ball joints is allowed.
After restoring ball joints and steering tips using SJR technology, car owners note a decrease in lubricant consumption

Advantages of the SJR 3
Automated lever clamp;
Innovative centering mechanism. Thanks to him, the master can cope with the repair of the part without outside help;
Integrated polymer melting system. A gas burner is needed only to extract the remnants of the old polymer from the detail. The new portion of fluoroplastic will be warmed up to the required temperature by the machine itself;
High piston pressure.

Package bundle
Extruder;
Control block;
Thermal sensor;
Bushings for centering the ball joints: 10 pcs.;
Washers for centering the ball joints: 5 pcs.;
Power cable;
Pneumatic equipment;
Pressure regulator;
Replaceable nozzles: 3 pcs .;
Fastening mechanism;
Centering mechanism;
Consumables polymer: 20 pcs .;
Gas-burner.

Ad number: 1792   |  views: 66  
,  Kharkiv, UA
Flagma member since 12 March 2018

Similar ads

N1 machine for restoration of repair of fuel sprayers
$4,300/pc CIP
Stanok expert, LLC, RU, 72 km +67 ads
N1 machine for restoration of repair of fuel sprayers The machine N1 allows to restore with maximum accuracy the geometry of the locking cone...
N2 Repair Machine of Piezo Nozzle and Common Rail Valve
$1,300/pc CIP
Stanok expert, LLC, RU, 72 km +67 ads
On the machine, it is possible to produce high-quality processing and grinding the seats for the needle in the spray gun housing. The N2 allows...
Show more
Contact the company
Стил Александр
менеджер
By phone
In messenger
Say, that you found an ad on Flagma
Safety rules: Do not agree to a prepayment if you are not sure about the reliability of the company.
Write a message
Select category
×
Login to your account